I installed this 12-24V wireless RF remote control relay switch. It works but the on wall switches stop working. Can someone please explain this to me what I did wrong? Thanks so much.
Since our relay only provides a simple on/off output, I think maybe you can try following.
Disconnect wires from receiver, just keep connected to wall switch.
Manually simulate the relay on/off by connect/disconnect wires.
Observe if the wall switches works normally.
Maybe you can consider using another relay terminals on receiver, or use shorter wires, it might help solve the problem.
Thanks.
This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.