TX134 remotes not pairing with 202U v5

I have a 202Uv5 installed and paired with two TX134 remotes. I tried pairing a third remote, and it did not work. So, I oredered two new remotes and those are not pairing either.

During “Storing Transmitter Code” step one (1), the SIG LED turns on, once pressed and held, but turns off when I release the PRG1 or PRG2 button. Should the SIG LED light stay on through step 2 and 3?

Hi,
For 202U v5, you will need to keep PRG button pressed during the programming procedure.
Please see video below for more details.

Thanks.

Thank you, that worked with the new remotes. As for the other remote that wont pair, the LED blinks when the button is pushed (new battery). I tried the procedure where you hold C+D down for 3-4 seconds and wait for the LED to blink, but the LED begins blinking when I begin to press C+D down, and stays blinking. Then, when I press the A button to switch modes, it just blinks. Ideas? Thanks,

I was able to fix this by removing the battery and reinstalling the battery while the “C” button was pressed. Released the “C” button once batter was installed and now the remote is back to functioning properly.

Yes, if your tx134 is a older model, refer to the video below for mode changes.

Thanks.

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.