TRYING TO ESTABLISH TWO ON/OFF ON 202U.

Wireless Receiver Kits
#1

THE LED WILL ONLY FLASH 2 QUICK THEN A PAUSE AND 3 SLOW. MY OBJECTIVE IS TO CREATE TWO INDEPENDENT SWITCHES TO TURN ON AND OFF LIGHTING IN THE REAR OF MY HOUSE. I HAVE THE CIRCUIT WIRED- FEED TO EACH RELAY ON THE COMMON AND THE SWITCHING ON THE NORMALLY OPEN. THE COIL VOLTAGE IS ON THE TERMINALS TO THE RIGHT.

#2

Hello Eric,

Let’s first get the remote programmed.

When programming, only press remote control button once then release (not long time), or receiver will erase the just learned code.

If you press remote control button long time, the LED will flash 3 slow flashes, and code is erased.

Please let me know if programming is good, then we can check wiring.

Thanks.

#3

Hello Eric,

Is there any news? please let me know if the problem is solved, thank you!

#4

Pressing and holding program 1 on the receiver board and pressing the button on the transmitter and releasing, only produces two rapid flashing leds. Do the pin switches have to be set for the hold function? I have them both set to on.

#5

Hello Eric,

After programming, does relay turn on and off?

For your LED on/off application, yes I recommend set to hold function, DIP 1-> ON, DIP 2->OFF as written on manual.

Please let me know if you have other questions, thanks.

#6

We have made a video for programming, here VIDEO - 202U V4 receiver programming and set working mode

#7