I have a 12 volt dc motor wired thru a dpdt switch that does what it is suppose to do. I would like to connect my kit-1 to my terminal strip so that it does the same thing. what dip switch setting do I use and what connections on your terminal strip do I use? the dc motor is double gear reduction so I’m hoping amperage is not a problem. max amperage?
I think I have the same/similar question. Have a 2 wire DC motor and I want it normally off, button one energize lead one and ground lead two. Remote button two connects motor backwards.
How? Thanks
To make 202U relays directly control DC motors.
Please make sure the motor rating is less than 12Vdc, 6A.
Does your motor meet above requirements?