Reset TX134 F4V4b remote to factory setting

Hi. I have the TX134 version F4 V4b remote (and a 202U V6e receiver).

When I first got it, it only transmitted the code on some lower frequencies, like 372.5MHz.
I then did the hold C+D 3 seconds, then A. At which point it switched to FSK in the 433MHz band.
I did the C+D 3 seconds, then A. And now it is back to sending KeeLoq in 372.5MHz but it ALSO sends signal on 433.9MHz.

It works fine, but is there a way to reset the remote to only use the lower band & not the 433MHz band?

I really prefer the original mode signal, without any signal on 433MHz band.

Thanks for any advice!

Hi,
I just asked our engineer, and the change has something to do with improving homelink compatibility.
I’m afraid there is currently no option to reset to original signal.
Maybe you can check other suppliers?
Thank you.

1 Like