I have a Patriot gate and the J2 connector has slots 1(12v+), 2(12v-), 3 (Push button input normally open), 9 (Free exit open input). I have tried the connections on the solid remote with power to power slots and the remote does properly engage both relay 1 and 2 as momentary but I cannot get the gate to function.
Would you please send me the link to the manual of your gate opener?
So I can check the connection, thanks.
— Also a quick checklist.
- use 12vdc to power 202u (if you haven’t done it).
- use NO & COM connection (not NC).
Here is the manual
I sent in the manual but I do not see my reply in this message stream. You can download it from this site - https://www.usautomatic.com/support/manuals
Any help here? I have submitted the manual and a link for the manual. I have tried getting the Solidremote product to work but it seems like it simply will not function for gates?
Just saw your link, it seems all your messages were caught in spam folder.
It seems your link doesn’t work right now, anyway I’ve found another pdf at http://www.gatetechsupply.com/images/NEWPAGEPATRIOT1.pdf
See page 14 of the manual, there is a TERMINAL 3 - push button input,when connect TERMINAL 2 & 3, will your door open / close ?
Yes connecting 2 and 3 will open and close the gate.
How do I connect 2 and 3 to the soildremote receiver? I need to have 1 and 2 going to the 12v Power, should I split 2 to goto Common and set 3 to NO on the relay?
You have 3 wires coming from your control board to our 202U.
+12V connect to our either power input terminal.
GND split into 2 wires
2.1) Goes to another power input terminal
2.2) Goes to relay 1’s COM
Control wire goes to relay 1’s NO
It should work, please let me know.
Thanks! That works!
By the way are there any pin pads or mountable buttons that work with the reciever?
Thanks for the update.
Sorry we only have keyfob remotes, sometimes customer use sticker to make it somewhat mountable.
Let me know if you have other questions.