Hello
I have a hangar door I’m trying to set up the 202UV6 for. The door motor is controlled by a three position wall switch spring loaded to center position. There are three leads going into the switch COM/UP/DN. I have wired the 202U in parallel with relay 1 UP and relay 2 DN. It is imperative that the two relays cannot be activated at the same time otherwise damage to the motor might occur.
So what I would like to do is to have each relay run a determined amount in time (90sec) in timed mode but also be able to stop it at any point. Also, only one relay active at a time. No possible way to activate both relays at the same time.