I just finished wiring up my project. It is replacing a solar powered gate opener controller. I got it all together and I have one controller that wont switch the relays. It will only start and stop independently. Any ideas of what is happening?
You mean turn on relay 1 then relay 2 auto switch off ?
Maybe have something to do with working mode settings, please check dip switches configuration.
Yes. It will not do that for one controller but the other does.The dip switch is configured the same.
Please try clear all settings below
And try set working mode again, when set dip switches, please make sure the tab is either fully up or down, never stuck in middle.
Thanks.
This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.